Forum Navigation
Post History: dancolwp1974
Hi Kelsh,
My first impression is that this seems like a challenge of finding the right power/spee …In: No ribbon cable and newer mini gerbil with a few other questions.
4 years ago
Hi Kelsh,
To answer your original questions.
1. There are multiple factories that make K40 …In: No ribbon cable and newer mini gerbil with a few other questions.
4 years ago
Hi @maxd,
@humptydumpty has it right, the last pin on the top right corner of your Mini Gerbil ph …In: Laser power doesn't seem to adjust
4 years ago
Thanks @jfinstrom, nice one.
How did you make that connector? Was it made from an existing cable …In: Custom PWM wire
4 years ago
Sorry, didn't see your USB 3.0 comment before I posted my response. We're not aware of an …In: Scan Speed Steppers Staling
5 years ago
Hi Eric,
I've looked at your $ settings and note they’re pretty much the default values that w …In: Steppers Grinding/Stalling after job completion.
5 years ago
Hi Eric,
the good news is that in LB 0.9.02 as long as you have the correct device installed, Li …In: Scan Speed Steppers Staling
5 years ago
Hi Eric,
I guess you mean 128,000 not 1,280,000 ?
Please set the Baud rate to 230,400, which i …In: Scan Speed Steppers Staling
5 years ago
5 years ago
Hi Eric,
If by manual, you mean pressing a button and changing the gantry position as you need it …In: Unlock Gantry, Manually Set Origin/Position
5 years ago
Hi Eric,
Thanks for posting video, that makes it easier for us to help you.
As per my other respon …In: Steppers Grinding/Stalling after job completion.
5 years ago
Hi Eric,
On the software front, please ensure you’re using v 0.9.02 or later of Lightburn. Some ea …In: Scan Speed Steppers Staling
5 years ago