Change your cover photoUpload Change your cover photoUpload Change your cover photo Paul Has BSc in electronics engineering and recently working as a Business Architect. Originally from the Netherlands but migrated to Australia after working on a telco project in 1998 which send him to Sydney to work with a software vendor. This user account status is Approved About About Posts Posts Comments Comments MG3 Air assist customisation 3 years ago in: Uncategorized no comments MG2 Air assist 4 years ago in: Dan's blog, K40 6 comments Release note MG firmware update 12353 4 years ago in: Dan's blog 9 comments Quality laser engraving – full detail 4 years ago in: Engraving, K40, Paul's blog 2 comments Adding a door safety switch to your laser 4 years ago in: Dan's blog, K40, Paul's blog 4 comments COVID-19 Delays 4 years ago in: Uncategorized 6 comments Limit switches and homing 5 years ago in: Uncategorized 1 comment SuperGerbil Board configuration 5 years ago in: Paul's blog, Super Gerbil 4 comments K40 Middlemen board for Super Gerbil and K40 5 years ago in: Paul's blog, Super Gerbil 5 comments K40 controller review 6 years ago in: Dan's blog, Super Gerbil 33 comments load more posts