Change your cover photoUpload Change your cover photoUpload Change your cover photo Paul Has BSc in electronics engineering and recently working as a Business Architect. Originally from the Netherlands but migrated to Australia after working on a telco project in 1998 which send him to Sydney to work with a software vendor. This user account status is Approved About About Posts Posts Comments Comments Hi, just email us via the contact page. Thanks Paul On Quality laser engraving (express version) Hi Glenda, you can use that laser configuration as well. Cheers On Tech support and debugging Note: K40's resolution is about 254-300 DPI (0.1mm beam) which widens when using high levels of power. Also the material… On Best possible K40 laser engravings Note: the K40 gantry and it's load (laser turret) are quite lightweight so it does not require a high powered… On Adding non-standard stepper motors to your K40 laser Hi Patrick, if pin compatible then it should be fine to use them. Note that the k40 motors take only… On Stepstick jumpers The latest release is https://github.com/paulusjacobus/awesome.tech/blob/master/MGfirmwareV8_1_1build12353.hex which has a small improvement with a G code status reply. I think your issue… On Mini Gerbil 2 firmware updating Hi Erik, We had a few requests for a WP output so you could use it to drive a solid… On Adding a door safety switch to your laser Hi Jason, yes you could do that but we found that S and $30 set to 1000 gives the best… On Controlling laser power Thanks Bront, the labels got misplaced since the msg door label is too long. We have updated the pictures. Well… On K40 peripheral control with Mini Gerbil The working of a limit switch can be checked via the question mark command. Just enter ? into the LB… On Limit switches and homing load more comments
