Change your cover photoUpload Change your cover photoUpload Change your cover photo Daniel Collins This user account status is Approved About About Posts Posts Comments Comments Hi, do you mean the laser has permanently lost burning power? To check this, please place a small piece of… On MG3 troubleshooting Hi Jon, I understand you have an MG2, but the page you're describing was written for the MG3. Please check… On Quality laser engraving – full detail Hi Matt, the MG3 price is $115 USD per unit, plus region specific 'shipping' prices determined by local postage, taxes… On Mini Gerbil 3 status update Please see https://awesome.tech/the-new-minigerbil-3-design-improvements-thanks-to-user-feedback/ More details and specs to follow On New Mini Gerbil model coming soon! Hi Robin, I've updated the article to describe switching low voltage DC and mains AC loads. Your link's SSR appears… On MG2 Air assist Hi Graham, a few questions: * what SSR did you use? Please send a link * please confirm you have… On MG2 Air assist Hi, we've recently transitioned to the new firmware, so sorry I can't guarantee which version you'll get. Once you have… On Mini Gerbil 2 firmware updating Sorry, 25mA is not enough to drive a traditional coil relay. SSR's are geared for switching mains loads so they… On MG2 Air assist Hi Julio, yes, you can always revert to the previous firmware, no problems. Regards, Dan On Release note MG firmware update 12353 Hi John, Thanks for checking - sorry to say the $G issue is still on the log of issues/improvements to… On Release note MG firmware update 12353 load more comments
