Forum Navigation
Post History: gmonsey
Uploaded a 3/16th version on Thingiverse, give it shot, maybe it will work for you.In: Simple Mods for my K40
5 years ago
I mention the baud rate because I do alot of tinkering with arduino's, micro's, nano' …In: Gerbil connection issue
6 years ago
If you have not figured it out yet:
Just a shot in the dark, but place a piece of paper in front …In: lazer not fireing
6 years ago
Check you baud rate, make sure 115200. I don't use lightburn, but have you attempted to connect …In: Gerbil connection issue
6 years ago
Tyler, yes I do.
Did you try to home the machine with Inkscape or an actual GCode sender? I can n …In: X-Axis not homing
6 years ago
The following are some simple items that I made for my K40, More to come as I test them out.
K40 …In: Simple Mods for my K40
6 years ago
Gerbil installed fine, runs great with CNCjs, homing, cutting and engraving. Just having problems ge …In: Inkscape crashes Home
6 years ago
Hello JohnA, Did you figure it out?
If not, can you also attach a close up picture of your power …In: Help with connecting from a HT-Master-6 board to Gerbil
6 years ago
Hello Sevrance, just out of curiosity, did you connect the single (pwm ) wire supplied to the IN on …In: K40 board does not have ribbon cable
6 years ago
Thank you for the Reply,
I actually run my 3D Printers at 280, but depending on the axis my CNC R …In: Power supply issues
6 years ago