Forum Navigation
Post History: Dbtoutfit
Thanks Paul and Dan,
Paul, I do not recall if I got any heat sinks or what I did with them.
Is 1 …In: Mini Gerbil Freezes mid Cut. (K40)
3 years ago
During Mid cut, usually about half way in and for some reason most the time it freezes about center …In: Mini Gerbil Freezes mid Cut. (K40)
3 years ago
Quote from Justin Reece on February 14, 2021, 1:01 am
@dbtoutfit ... did you ever find a fix for th …In: Mini Gerbil: Laser on/off vs. PWM outputs
3 years ago
Been so long since I had my POT hooked up I didn't think about that.
However my NewlyDraw boar …In: Etching leaving Profile Marks (Ghosting) and Traverse Lines
3 years ago
Wished it didn't take me so long to find.
See above where I mentioned purchasing a second PS …In: Etching leaving Profile Marks (Ghosting) and Traverse Lines
3 years ago
Ok so I think I finally got it for good.
In the wiring document it states the 5v and GND of the P …In: Etching leaving Profile Marks (Ghosting) and Traverse Lines
3 years ago
I have had this come and go since I got the MG.
I have replaced wires, soldered the molex plug pins …In: Etching leaving Profile Marks (Ghosting) and Traverse Lines
3 years ago
Did you ever get this resolved?
I have been fighting since I got my MG to stop this and ghosting …In: Faint Line during travel
3 years ago
So looks like I found the culprit.
I just finished my new 48x48 CNC Router build and learned a lot …In: Etching leaving Profile Marks (Ghosting) and Traverse Lines
5 years ago
As you can see in the pic I am getting a profile at the edges where the over scan max is.
What caus …In: Etching leaving Profile Marks (Ghosting) and Traverse Lines
5 years ago
Sometimes when I fire up the machine and machine auto homes the stepper will stall/grind.
I cycle …In: Stalling Grinding sometimes on startup.
5 years ago
That Mirrors my settings, yes.
Must be my USB/CAT5 Cable
Long ago I made a Cat5 w/ term blocks …In: Scan Speed Steppers Staling
5 years ago
So I spent the whole day since about 9am working on the gantry etc.
I put a whole new gantry, belt, …In: Steppers Grinding/Stalling after job completion.
5 years ago
Thinking being on USB 3.0 might be the reason I swapped the MG to 3.0 port and the computer doesn� …In: Scan Speed Steppers Staling
5 years ago
Sorry got carried away with the Zero's. 🙂
There isn't anywhere in LB I can find like p …In: Scan Speed Steppers Staling
5 years ago
I think they removed the Braud Rate from LB a Version or two back.
Several days ago I did set the B …In: Scan Speed Steppers Staling
5 years ago
Your a life saver!
I have had the ability to do this for so long I was really missing it with the …In: Unlock Gantry, Manually Set Origin/Position
5 years ago
Thanks for the reply Dan.
My steppers had been performing well at 320-350mm/s with the older cont …In: Steppers Grinding/Stalling after job completion.
5 years ago
I can not find the reason yet but everyday at some point this problem starts where the steppers stal …In: Steppers Grinding/Stalling after job completion.
5 years ago
This would be interesting to me as well.
It seems that I can not generate fast enough pulses to eng …In: Mini Gerbil: Laser on/off vs. PWM outputs
5 years ago