Forum Navigation
Post History: xlblackinklx
Thanks, but I'm on Windows 7, and when I open CNCjs to connect to the laser, it connects but th …In: Flashing Firmware
7 years ago
So I'm not sure what happened, but my computer is no longer reading the gerbil controller. I p …In: Flashing Firmware
7 years ago
So has anyone tried the TMC2100 or TMC2130 stepper drivers with this board?
I'm looking to q …In: TMC2100 Stepper Drivers
8 years ago
Quote from Paul DeGroot on April 9, 2018, 1:25 am
Quote from xlblackinklx on April 7, 2018, 2:48 …In: Error sending gcode
8 years ago
Not sure what happened, but I got it working again by flashing the grbl firmware.In: Error sending gcode
8 years ago
Update:
$H command works, however attempted to change the value of a parameter results in "E …In: Error sending gcode
8 years ago
So yesterday I engraved and cut several pieces... Today I'm suddenly getting an error when atte …In: Error sending gcode
8 years ago