Forum Navigation
Post History: Nigel Jones
When I connect the pem wire the test button on the power supply no longer works. I think something m …In: Need help, nothing working
8 months ago
Sometimes I have low power, sometimes nothing, could it be computer related?In: Need help, nothing working
8 months ago
I am now back to low laser power, hardly enough to mark mdf board but the laser is firing.In: Need help, nothing working
8 months ago
I am now confused. The laser fires with the test button ONLY if the pwm from the MG3 is disconnected …In: Need help, nothing working
8 months ago
I noticed that the red test button is not working. I will try another power supply that i have. I cr …In: Need help, nothing working
8 months ago
The tube is new, maybe a couple of months old, wouldn't of done 3 hours yet. Do any of LEDs 4,5 …In: Need help, nothing working
8 months ago
My k40 with MG3 is only giving out 2-3 mA. Led 4, 5, and 6 are off. Earth is good. Any ideas.
Tha …In: Laser low power
8 months ago
Now I can't get more than 2 - 3 mA with the laser, so it won't cut or engrave. I have the …In: Need help, nothing working
8 months ago
I am away until Sunday, I will check then. Thank you so much for your help.In: Need help, nothing working
8 months ago
I have installed an MG3 into a K40. Even when I get connection I get no movement, no laser. I also …In: Need help, nothing working
8 months ago
5 years ago
I am using Windows 10 but I downloaded a driver from your website. Should I uninstall the driver I d …In: Still not working
5 years ago
Hi I have tried to connect as per your instructions but I am having trouble with it seems the driver …In: Still not working
5 years ago