Forum Navigation
Post History: Flex1
Paul,
Yes, I would like to exchange the controller.
Can you provide an email that I can forwar …In: Need Help with Homing Issue
5 years ago
IS IT POSSIBLE TO GET A REFUND FOR THE CONTROLLER?
If the K40 Nano fixes the homing issue, can I …In: Need Help with Homing Issue
5 years ago
Is it possible to remove the Mini Gerbil and re-connect my K40 Nano Controller?
I need to revert …In: Need Help with Homing Issue
5 years ago
Paul,
The Y-Axis is the only axis that appears to be operating as intended. The X-Axis is causing …In: Need Help with Homing Issue
5 years ago
Paul,
RESULTS with X-AXIS at 0 & Y-AXIS at 0
?
<Idle|MPos:0.000,0.000,0.000,0.000,0. …In: Need Help with Homing Issue
5 years ago
Paul,
Is there any way you can send me the photo showing the bridge jumper?
" to set the …In: Need Help with Homing Issue
5 years ago
Is there anything else that can be tried,? If not, I would like to exchange the controller.
.In: Need Help with Homing Issue
5 years ago
Paul, I've tried separating the cabling from the limit switches and had no luck. I have 4 wires …In: Need Help with Homing Issue
5 years ago
Paul,
I have a mechanical limit switches. I also tried changing $26=350, but that had no effect o …In: Need Help with Homing Issue
5 years ago
I have a K40 laser with manual X & Y limit switches and the laser head is configured to “home” b …In: Need Help with Homing Issue
5 years ago
Yesterday, I replaced my 16L/min water pump with a 20L water pump. I think the older water pump was …In: Bad Laser Tube???
5 years ago
Paul,
I need your opinion on what I believe to a laser tube problem with my newly installed laser …In: Bad Laser Tube???
5 years ago
Paul, I would like to thank you for your support. Your suggestions were extremely helpful and exact …In: Bad Laser Tube???
5 years ago
Paul, is my recently discovered "tube break" similar to what you experienced?
I've …In: Bad Laser Tube???
5 years ago
Hello,
I have a K40 Laser with less than 10 hours total usage. Newly installed Mini Gerbil 1.1 Co …In: Bad Laser Tube???
5 years ago
Hi, I believe I corrected the issue. I found this photo and realize I never made a connection betwee …In: Laser won't shutoff during travel
5 years ago