Forum Navigation
Post History: tprothma
It's Uno Analog In Pin 3, it is labeled on the shield with the ribbon cable pointed up it' …In: Pendant with Air Assist
5 years ago
For connecting air assist relay Paul pointed me to cpumap.h to make a possible firmware change, but …In: Pendant with Air Assist
5 years ago
I'm planning on building a pendant for stop, pause, go, reset with air assist. First question …In: Pendant with Air Assist
5 years ago
Actually it looks pretty good. Some plywoods are tough to dial in. What material are you using? Wh …In: Greyscale imaging
5 years ago
I quickly found that the $30 and Smax are not integers so fractional values (floats) are interpreted …In: Greyscale imaging
5 years ago
dfox1787,
I've been doing a lot of engraving with a laser diode, so I have not fully charac …In: Greyscale imaging
5 years ago
ok, great. This really good info. BTW, I noticed the sensitivity of the POT on the A4988's an …In: T2laser testing
5 years ago
oh, ok. That confirms my hunch as I think the drivers were previously set to 1.2V and things were n …In: T2laser testing
5 years ago
ok, everything is working great with the new board.
I found that you can in debug mode for T2 or …In: T2laser testing
5 years ago
Quote from sgraber on February 24, 2018, 4:15 am
FYI it took a bit to figure out how to compile the …In: LightBurn Software?
5 years ago
You should be able to search and replace M03 with M04 and it should run.
M03 does not fire the la …In: LightBurn Software?
5 years ago
Oh, in addition to the 10 pin on the ribbon cable that connects to the USBasp, it looks like there a …In: T2laser testing
5 years ago
I think this one will work to adapt the 10 pin on USBasp to the 6pin ISP header on the Arduino.
h …In: T2laser testing
5 years ago
Great... Can you post a picture of one plugged in. I don't see a 10 pin header on the base boar …In: T2laser testing
5 years ago
Hi Paul, I really appreciate the offer. I'm happy and a little confused though. I though USBa …In: T2laser testing
5 years ago
ok, my epiphany is this...
In grbl there is a $30 max power parameter (or max spindle parameter) …In: T2laser testing
5 years ago
ok, I had an epiphany on the way to work as my brain was working in the background trying to reconci …In: T2laser testing
5 years ago
Hi Paul,
The zipped hex file definitely works. Thanks for fixing the download link.
I definite …In: T2laser testing
5 years ago
Picture 1) Before zadig I had a Port-> USB Serial Port in Device manager
Picture 2) With zadig …In: T2laser testing
6 years ago
After finally getting eXtreme Burner AVR to run, I still have issues. It looks like the libusb0.dl …In: T2laser testing
6 years ago
6 years ago
Got it homing and otherwise behaving properly, but hit a snag.... My firmware seems to be incorrect …In: T2laser testing
6 years ago
ok, there may be a better way to enable test fire, but frankly I don't follow the installation …In: T2laser testing
6 years ago