Forum Navigation
Post History: Phil Herms
solved my problem.
Set machine origin in LB to bottom left. (LW has the same).
Set $ …In: K40 l Lightburn and LaserWeb different movement directions
3 years ago
thanks for your answer Paul!
Do I see it right that there is no other Way to match Lightburn and …In: K40 l Lightburn and LaserWeb different movement directions
3 years ago
Hey guys,
need your help with my K40.
Limit Switches are in the upper left.
To use Lightbur …In: K40 l Lightburn and LaserWeb different movement directions
3 years ago
Hey Paul, thanks for your answer.
I re-seated all connectors - but with no success. I previosly i …In: laser doesn't fire exactly faster than 50mm/s with my K40
3 years ago
Hey guys,
I have some issues with ma K40 & Mini Gerbil.
If I want to engrave fas …In: laser doesn't fire exactly faster than 50mm/s with my K40
3 years ago
hey Paul, thanks for your answer.
I will try to re-connect the power-wire.
I fixed it with hot g …In: PWM Control issues (laser is firing more than set in software)
3 years ago
Hey guys,
I have some issues with my mini gerbil.
I tried to engrave some slate. I set power to …In: PWM Control issues (laser is firing more than set in software)
3 years ago
I found another solution in an another forum.
I made two Macros. One with FREE MOVE ON
…In: Mini Gerbil beginner issues (Optical End stops, No working firmware, Unlocking Laser motors)
3 years ago
did it like this but it doesn't work at all 🙁In: Mini Gerbil beginner issues (Optical End stops, No working firmware, Unlocking Laser motors)
3 years ago
Quote from Paul DeGroot on June 27, 2020, 8:44 am
Hi, Yes you can issue a $X command which unlocks …In: Mini Gerbil beginner issues (Optical End stops, No working firmware, Unlocking Laser motors)
3 years ago