Forum Navigation
Post History: paradug
Dave,
With the mini-gerbil addins, I had an issue with svgpathtools library being required, but n …In: Driver update
5 years ago
Paul,
I am wondering if I might be getting some noise from the 24V laser supply, resulting in som …In: Driver update
5 years ago
Dave,
Would you be willing to post your $ settings on the mini-Gerbil with LightBurn? I have it w …In: Driver update
5 years ago
On the LightBurn forum, K40JF posted his settings for LightBurn using a older K40 Gerbil. After look …In: LightBurn with mini-gerbil
5 years ago
Have you checked your focus? If you try to cut a piece of cardboard (say from a cereal box), does th …In: How to configure PWM?
5 years ago
The max power of a K40 is about 15 to 19 mA depending on weather and laser tube water cooling temper …In: How to configure PWM?
5 years ago
I am using the mini-gerbil, and I am having problems setting up Lightburn. As received the mini-gerb …In: LightBurn with mini-gerbil
5 years ago
Found an image of the connector on the older K40 Gerbil board. Both boards have the same pinout.
…In: What is the pin out of the alternate end stop connector J5
5 years ago
What is the pin out of the alternate end stop connector J5 on the mini-gerbil. It would be neat to h …In: What is the pin out of the alternate end stop connector J5
5 years ago