Forum Navigation
Post History: Keith Ealanta
Thanks! I had been using the +5V on the (optional) Alternative Limit Input (bottom right on the boa …In: What are the best point to source power?
8 months ago
Quote from Paul on December 3, 2024, 1:48 pm
Humm, when the mount end it's on the gantry bar e …In: Photo's of the drag chain installed
8 months ago
Theres probably a better spot to show it, but here's the first test piece I did for my current …In: Ummm Help? Stream not completing
8 months ago
I'm attaching a targeting laser and a switched air-pump to my system.
I know about the pin for …In: What are the best point to source power?
8 months ago
Thanks Paul - I'm not sure which of two changes fixed it, but it seems to be working now.
The …In: Ummm Help? Stream not completing
8 months ago
Thanks Paul.
My impression is that some sort of "end of processing" signal isn't bei …In: Ummm Help? Stream not completing
8 months ago
I've had my k40 and Gerbil for a good while now. I had it all running fairly well, and was sta …In: Ummm Help? Stream not completing
8 months ago
Has anyone looked at ways to control head position from on the K40 itself? Or does anyone have any …In: On-device head positioning.
11 months ago
Thanks Paul,
I was misunderstanding the instructions - I thought from my reading I could have M7 co …In: targeting laser
11 months ago
Actually, Paul, any tips for zero-width limit switches? I'd like limit switches, but I don …In: Photo's of the drag chain installed
11 months ago
Thanks for the thoughts - You can see the air assist tube in the pic, so that one is sorted.
The ai …In: Photo's of the drag chain installed
11 months ago
Thanks for the suggestion mathiaspl20.
To reduce the amount the chain pushed into the laser path, I …In: Photo's of the drag chain installed
11 months ago
Has anyone attempted to add a targetting/sighting laser to their K40?
I've wired one up with. …In: targeting laser
11 months ago
