Forum Navigation
Post History: Badass52
Paul,
Been super busy at work. I did get the new board in and finally got it installed this morni …In: Well, I guess I give up on the Gerbil!
5 years ago
oops, I put an e in my email address that doesn't belong there, The correct email address is rp …In: Well, I guess I give up on the Gerbil!
5 years ago
Hi, I have the legacy Gerbil and that would be very much appreciated if I could get it repaired or r …In: Well, I guess I give up on the Gerbil!
5 years ago
I have tried about everything I can find online and this thing just won't work correctly.
I …In: Well, I guess I give up on the Gerbil!
5 years ago
I have set them at 0.72 and I was running some tests and I find the X axis motor seems to get hot wh …In: How to set the current on the step driver
5 years ago
Hi,
When running test files on scan or cut it seems that the axes are jumpy and noisy as like the …In: When running with lightburn both axes jumpy
5 years ago
Hi,
I purchased my Gerbil during the kick start and am finally trying to install it on my machine …In: How to set the current on the step driver
5 years ago
So Paul, when I install mine into my machine do I need to provide a 5 volt source to the barrel plug …In: Gerbil First Time Use - no go
6 years ago
So is the lens you included better than the stock lens as mine still works fine with the original co …In: Optic lens
6 years ago
6 years ago