Forum Navigation
Mini Gerbil in 60w Lasercutter with different Power-supply
#16 · October 28, 2020, 8:06 am
Hi Simon, the TL signal might need an additional pull up resistor of 10kOhm. The resistor goes between TL and 5VDC. The TL connection goes to the LO connection on the MG board.
Please let me know if that helped.
Cheers Paul
Cheers,
Paul
awesome.tech
#17 · November 8, 2020, 2:31 am
Hello Paul, today i tried it and it didn't work.
I connected TL with 5VDC and TL with GND (both times with the 10kohm resistor) and both times the laser fires as soon as i push the laser switch to on.
It doesn't helped.
Do you have another idea?
Best regards
Simon