Forum Navigation
Post History: Roberth8
Thanks for the instructions .
I have been debugging this for quite some time now and the other i …In: Power increase after engraving for a while.
5 years ago
Update:
The little K40 has been working flawlessly with the pot wired in. It does suggest that the …In: Power increase after engraving for a while.
5 years ago
Well, even with just setting the beam strength with the psu pot only arrangement, I am still getting …In: Power increase after engraving for a while.
5 years ago
Did you still want a photo posted or are there other diagnostics I can complete?In: Power increase after engraving for a while.
5 years ago
Yup, that worked. Just connecting the GND pin did the trick and the pot attenuates the beam accordin …In: Power increase after engraving for a while.
5 years ago
Well I finally got my pot from China and installed it as you said, middle pot pin to IN.
The laser …In: Power increase after engraving for a while.
5 years ago
Thanks gain for your help Paul.
I checked and rechecked the connections in the PSU and to the tub …In: Power increase after engraving for a while.
5 years ago
Hi Paul.
All in all the Mini Gerbil is performing well on my K40.
However, after about 10-20 min …In: Power increase after engraving for a while.
5 years ago
Hi Paul.
What a world it would be if everyone provided such stellar tech support as your's.
…In: Laser not turning off even during position moves.
5 years ago
Hi gang.
I sincerely apologize if this has been answer elsewhere.
I am having intermittent pro …In: Laser not turning off even during position moves.
5 years ago
Is this not a thing of beauty?!!!
I was so excited I came running in from the "workshop" …In: PWM Intermitent response:
6 years ago
Thanks Paul.
A new USB cable is on its way.
It is a fairly new K40 unit so I think the tube is …In: PWM Intermitent response:
6 years ago
Hi again gang.
I am sssoooo close to getting this sorted.
I have had real success over all and j …In: PWM Intermitent response:
6 years ago
Also, when I swapped the sticks I got an error 9.
Unable to burn at all.
Any thoughts on that? …In: Lines on engraving and engraving quality issues.
6 years ago
Thx Paul.
Where would I put my multimeter probes to measure the step stick output that would be c …In: Lines on engraving and engraving quality issues.
6 years ago
Yup. I was currently using .1 and .85 but will try .o42/600 as I see in your pic and 3000.
I see …In: Lines on engraving and engraving quality issues.
6 years ago