Forum Navigation
Post History: Brandon Whitton
Quote from Paul DeGroot on April 9, 2018, 1:29 am
If you install cncjs you can do test fires from w …In: Laserweb
6 years ago
grey offset and compression settings explained
https://github.com/paulusjacobus/Gerbil/ …In: Setting the laser power on raster engravings?
6 years ago
Think I got it. Using CNCJS:
$30= max power I want the laser to receive from power supply.
Las …In: Setting the laser power on raster engravings?
6 years ago
When raster engraving, the gerbil is going into hold state intermittently. There is no rhyme or reas …In: Gerbil continually goes into hold state
6 years ago
This is one of my first runs. I tested a couple things to learn some of the settings and then ran th …In: Comic art
6 years ago
As I learn and understand stuff like this I continue to post. Just in case the next guy googling aro …In: Setting the laser power on raster engravings?
6 years ago
I guess it's because the instructions say to go higher on $30 if the piece is too dark. Well go …In: Setting the laser power on raster engravings?
6 years ago