Forum Navigation
Post History: Simon Saslona
Hello Paul, today i tried it and it didn't work.
I connected TL with 5VDC and TL with GND (bot …In: Mini Gerbil in 60w Lasercutter with different Power-supply
3 years ago
Hello Paul,
i connected the TL to GND and the Laser burned all the time, after that i connected the …In: Mini Gerbil in 60w Lasercutter with different Power-supply
4 years ago
Hello Paul,
the voltage level on LO was roundabout 3 V. No matter if I ran a job or not.
What …In: Mini Gerbil in 60w Lasercutter with different Power-supply
4 years ago
Hello again,
i measured the PWM pin. There is constantly 4,95V, when i start a job on 10% it goes …In: Mini Gerbil in 60w Lasercutter with different Power-supply
4 years ago
Hello Paul,
i connected the WP and GND from the Power supply with the common ground on the Mini G …In: Mini Gerbil in 60w Lasercutter with different Power-supply
4 years ago
Could you please specify where I should connect them on Ground? On the gerbil (power-plug) itself? T …In: Mini Gerbil in 60w Lasercutter with different Power-supply
4 years ago
Hello again,
I connected the "LO" from the MiniGerbil with "TL" on my power s …In: Mini Gerbil in 60w Lasercutter with different Power-supply
4 years ago
Hello Paul,
did I understand right, that I only have to connect TL on the Power supply with LO on …In: Mini Gerbil in 60w Lasercutter with different Power-supply
4 years ago