Forum Navigation
Post History: licensed2hench
Thanks for looking it up for me.
I threw a meter on it. The 5v supply is actual around 4.7 and th …In: Higher Laser Power setting causing stepper motors to loose steps
4 years ago
I have a legacy grbl controller with GRBL 1.1e hooked up to a k40 using lightburn to send g-code.
…In: Higher Laser Power setting causing stepper motors to loose steps
4 years ago
Switching over to the GRBL device driver I tried both macros.
Both burned. Laser ON stayed active.
…In: Legacy Gerbil GRBL-M3 No Laser ON with M3
4 years ago
On GRBL-M3 I set $32=0 and it there still was no burn.
I tried the macro:
$32=0
S200
M3
G4 P1 …In: Legacy Gerbil GRBL-M3 No Laser ON with M3
4 years ago
I have a legacy grbl controller with GRBL 1.1e hooked up to a k40 using lightburn to send g-code. I …In: Legacy Gerbil GRBL-M3 No Laser ON with M3
4 years ago
I set:
$30=255 (Max RPM/Power)$31=0 (Minimum RPM/Power)
This did the trick!
Originally it was …In: Different Power Supply - where to add laser wire?
6 years ago