The Super PPA needs:
A) A Standard PPA input board, with just two extra 4 pin headers to act as the primary input board. Please complete the Standard input board instructions, and add 4 pin headers to the following PCB locations:
- BANK2IN
- PWR-OUT
Do not solder a 4 pin connector to BANK2OUT on the primary Input board
B) A secondary input board
This is a simplified version of the primary input board. Solder the
- resistors
- capacitors
- chip sockets IC1, IC2 and IC3 (IC4 is not required)
- LED
- 4 pin connectors PWR-IN, X0/4, X1/5, X2/6, X3/7, BANK2OUT
- wire links to R15 and WLINK
The Arduino headers are not required.