Quote from
mrs on October 28, 2018, 4:38 pm
Hi
Having a few problems with installing the Gerbil! I can connect to CNCJs but when I try to home it will not move on the X axis. Typed in ? and it does seem that both end stops are recognised but I get Alarm 9 as it times out on the X axis with no movement. I have optical sensors. I have tried G0 with X and Y. Y moves but no moment on the X. Is this controlled with the ribbon?
Any help is much appreciated!
D
Hi
Having a few problems with installing the Gerbil! I can connect to CNCJs but when I try to home it will not move on the X axis. Typed in ? and it does seem that both end stops are recognised but I get Alarm 9 as it times out on the X axis with no movement. I have optical sensors. I have tried G0 with X and Y. Y moves but no moment on the X. Is this controlled with the ribbon?
Any help is much appreciated!
D