Forum Navigation
x and y swapped
#1 · April 29, 2023, 3:49 am
Hello,
i am building a mini grbl v3 an old laser. But now x drive when i send command for y and vice versa. The direction is correct and the homing works correctly.
only x and y are swapped. can I teach this to the controller with a $ command?
#2 · April 30, 2023, 1:20 pm
Hi Marin,
I've never heard of this before!
There's no way to swap X and Y axis definitions in firmware. Why not swap the X and Y cables?
Regards,
Dan