Strange homing behavior
Quote from davegalesr on March 11, 2019, 9:24 pmI have noticed that homing does not work as expected when a print job is canceled in Lightburn. After canceling a task, I do a home in Lightburn but only the Y axis homes - the X axis position does not change. If I power off the K40, the X still does not home when I power it back on. Not a big deal since I can manually move back to home and Lightburn homes both axis when a print ends normally. Not sure if this is a Lightburn issue or a grbl issue.
I have noticed that homing does not work as expected when a print job is canceled in Lightburn. After canceling a task, I do a home in Lightburn but only the Y axis homes - the X axis position does not change. If I power off the K40, the X still does not home when I power it back on. Not a big deal since I can manually move back to home and Lightburn homes both axis when a print ends normally. Not sure if this is a Lightburn issue or a grbl issue.
Quote from Rickm1947@aol.com on September 13, 2019, 12:22 pmDave,
Where you able to fix this problem? I am having the same issue. It was working fine but today I am having the same problem you describe with the Y-axis homing and the X-axis not.
Thanks
Dave,
Where you able to fix this problem? I am having the same issue. It was working fine but today I am having the same problem you describe with the Y-axis homing and the X-axis not.
Thanks