Software issues
Quote from snow on May 5, 2019, 2:20 pmHi,
Ive been trying to get going with my mini gerbil but im facing some software related issues. I comnected to the gerbil with cncjs and all seemed fine so i went on and downloaded lightburn, dialed in the basic settings and then i did a test cut. Right after i had finished that cut it froze and i had to reset the controller to get a connection again. I proceeded with trying to cut the same file once more however now light burn would say it completed the cut when it was only roughly 5 seconds in and homed to origin. Tried over and over but it keeps doing the same thing. It fires properly and motors sound fine, lightburn just says "stream completed 0:00" after having started any job wether its a simple line or image. Any thoughts on this would be greatly appreciated!
Greetings,
Jules Peeters
Hi,
Ive been trying to get going with my mini gerbil but im facing some software related issues. I comnected to the gerbil with cncjs and all seemed fine so i went on and downloaded lightburn, dialed in the basic settings and then i did a test cut. Right after i had finished that cut it froze and i had to reset the controller to get a connection again. I proceeded with trying to cut the same file once more however now light burn would say it completed the cut when it was only roughly 5 seconds in and homed to origin. Tried over and over but it keeps doing the same thing. It fires properly and motors sound fine, lightburn just says "stream completed 0:00" after having started any job wether its a simple line or image. Any thoughts on this would be greatly appreciated!
Greetings,
Jules Peeters