Software ignoring $30 spindle speed
Quote from MattyO on March 31, 2019, 12:55 amI have an odd issue where all of the sudden $30 spindle speed is being ignored by Lightburn. I don't think it is a light burn problem. But I am unsure. It wasn't till I looked at my Amp meter during a cut at 80% and realised the amps were up over 20. So I adjusted $30 down to 1500 thinking this would reduce the 80% value. But it made no difference. If I adjust the power value within Lightburn it works fine. But I used to have it so when it was set to 100% it was about 18 amps. I have no idea what is going on. Any help would be appreciated.
Thanks Matt
I have an odd issue where all of the sudden $30 spindle speed is being ignored by Lightburn. I don't think it is a light burn problem. But I am unsure. It wasn't till I looked at my Amp meter during a cut at 80% and realised the amps were up over 20. So I adjusted $30 down to 1500 thinking this would reduce the 80% value. But it made no difference. If I adjust the power value within Lightburn it works fine. But I used to have it so when it was set to 100% it was about 18 amps. I have no idea what is going on. Any help would be appreciated.
Thanks Matt
Quote from Paul on May 15, 2019, 4:16 pmHi Matt, the S max value in LightBurn needs to correspond with the controller's $30 value.
Hi Matt, the S max value in LightBurn needs to correspond with the controller's $30 value.
Uploaded files: