Slow speed in grayscale
Hi.
In Lighburn, if I select the grayscale option, when I start it starts slow and sometimes it's like 1 minute at a slow pace and then it sets the rhythm that I have set in Lightburn, it only happens to me in the grayscale mode, could someone tell me What is due?
Another doubt, in the firmware where I select the maximum speed for the X axis, because in Lightburn but put 300mm / s this does not advance more than about 200mm / ss.
Thank you
The default settings are very conservative in order to have a plug and play experience. When the installation is successful and you get to know the controller you need to tune the settings to get the best possible speed out of the machine.
The X axis is capable of doing 375 mm/s but you need to set the proper belt tension.
The $ settings for a proper tuned machine are:
$110=24000 (feedrate mm/sec)
$111=8000
$121=5000 (acceleration mm/sec2)
Cheers!