Forum Navigation
No x axis movment
#1 · May 8, 2018, 8:19 pm
I just installed my board and got my gantry moving with CNCjs. I can jog my Y-axis fine but nothing happens when I try to jog the X-axis. so I started checking my connections on the board and noticed that my ribbon connector is 180 degrees from the one pictured in the instructions. I tried turning my ribbon around in the connector but it didn't change anything. could this be a misassembled board or where else should I look for the problem?
Uploaded files:
#2 · July 13, 2018, 9:04 pm
Hi Elliot,
I see you have a blue shield version, we have upgraded the shields since to have suppressor capacitors on the limit switches connections (only necessary for mechanical switches with bad wire routing). PM me and I will get you a new shield at no cost.
Cheers,
Paul
awesome.tech