Hello. I installed Mini Gerbil to K40.
It didn´t home, even move axises. When I tried to move Axis X, only vibrates.
Axis Y does nothing.
I tried to tune pots, bought new drivers, check jumpers under drivers.
Nothing helps. When i tried to home manualy in LB, it pops message in COnsole says "Timeout to find endstops" or something similar.
Can anyone help? Thanks
Hello. I installed Mini Gerbil to K40.
It didn´t home, even move axises. When I tried to move Axis X, only vibrates.
Axis Y does nothing.
I tried to tune pots, bought new drivers, check jumpers under drivers.
Nothing helps. When i tried to home manualy in LB, it pops message in COnsole says "Timeout to find endstops" or something similar.
Can anyone help? Thanks
dancolwp1974 has reacted to this post.