need help
Quote from Brent on September 16, 2019, 3:33 amneed help. nothing is working. ive tried everything. triple checked the install. made sure wires are in the right spot.Mini gerbil seems to connect to lightburn. STMicroelectronic wa downloaded but not sure if its connected? running on windows 8. Had moshi MS0105 v4.85 no ribbon. wont home, wont move. i can test fire from the machine but that it. im going to install moshi back in untill i can get further help, otherwise may need to return MG.
need help. nothing is working. ive tried everything. triple checked the install. made sure wires are in the right spot.Mini gerbil seems to connect to lightburn. STMicroelectronic wa downloaded but not sure if its connected? running on windows 8. Had moshi MS0105 v4.85 no ribbon. wont home, wont move. i can test fire from the machine but that it. im going to install moshi back in untill i can get further help, otherwise may need to return MG.
Uploaded files:Quote from Paul on September 16, 2019, 7:17 amMost important is to debug the issues one by one to find the root cause.
- The controller connects - check
- Does the gantry unlock when issue a $X command?
- If so, can you move the motors? If not, may be the motor are cross wired (use a multi meter to measure the coil wiring) or aren't getting 24V DC...
- etc
- see https://awesometech1.wpengine.com/mg-troubleshooting-guide/
Most important is to debug the issues one by one to find the root cause.
- The controller connects - check
- Does the gantry unlock when issue a $X command?
- If so, can you move the motors? If not, may be the motor are cross wired (use a multi meter to measure the coil wiring) or aren't getting 24V DC...
- etc
- see https://awesometech1.wpengine.com/mg-troubleshooting-guide/