Quote from Paul on April 17, 2022, 2:00 pm

In a nutshell: reduced noise from the power supply by using Optocouplers,  increased gantry speed, led indicators to help with troubleshooting,  air assist output. See https://awesome.tech/mg3-specifications/

 

Cheers Paul

Quote from riley1234198 on April 17, 2022, 2:35 pm

Thanks for the reply i also use a LX4 board and notice with the MG2 if i do a vector in engrave the MG2 looks blurry must be the noise i did insulate the PMW wire with aluminum foil and black electrical which did help a lot, when i get the MG3 will post some pics.

 

Thanks

Quote from riley1234198 on April 24, 2022, 12:56 pm

Just noticed on the website that sales wont be back till sales will reopen 1 May 2023? When i ordered my board that message was not on there.