M3=off M4=on
Quote from iamdaniel on July 21, 2020, 7:06 amHey guys, I've dug my old K40 out and i'm struggling to get her going again.
Tube is fine, burning good.
My issue lies with the M3,M4,M5 codes
In console they act like,
M3=offM4=on
M5=nothing
I'm trying to run lightburn as i've had enough of cncjs.
Board will not fire on GRBL-M3
Will not respond on Gerbil-STMWill work on GRBL but laser is continuously on.
Can you guys shed any light on this please?
Thanks, Dan
Console output:[spoiler]
Grbl 1.1e ['$' for help]
[MSG:'$H'|'$X' to unlock]
[MSG:Caution: Unlocked]
ok
$$
$0=10
$1=255
$2=1
$3=2
$4=0
$5=1
$6=0
$10=31
$11=0.010
$12=0.002
$13=0
$20=0
$21=0
$22=1
$23=3
$24=600.000
$25=1000.000
$26=250
$27=5.000
$28=0.000
$30=2048
$31=5
$32=1
$100=160.000
$101=160.000
$102=250.000
$110=3000.000
$111=3000.000
$112=500.000
$120=3000.000
$121=3000.000
$122=10.000
$130=320.000
$131=230.000
$132=200.000
ok
[/spoiler]
Hey guys, I've dug my old K40 out and i'm struggling to get her going again.
Tube is fine, burning good.
My issue lies with the M3,M4,M5 codes
In console they act like,
M3=off
M4=on
M5=nothing
I'm trying to run lightburn as i've had enough of cncjs.
Board will not fire on GRBL-M3
Will not respond on Gerbil-STM
Will work on GRBL but laser is continuously on.
Can you guys shed any light on this please?
Thanks, Dan
Console output:
Quote from Paul on July 21, 2020, 10:09 amHi Daniel, it's hard to tell. Probably the LO connection is loose hence the laser stays on. $28 should be 5 (1.5kHz). A zero setting equals 60 Hz which is a bit low.
Hi Daniel, it's hard to tell. Probably the LO connection is loose hence the laser stays on. $28 should be 5 (1.5kHz). A zero setting equals 60 Hz which is a bit low.
Quote from iamdaniel on July 21, 2020, 6:06 pmMorning, I'll check the LO wire later today, it is just a jumper cable so it is possible.
Hopefully the $28 setting will help too.
Morning, I'll check the LO wire later today, it is just a jumper cable so it is possible.
Hopefully the $28 setting will help too.