light burn with gerbil
Quote from carlos805 on April 21, 2018, 4:11 pmWhen i home the device the laser tries to run off bed and keeps bumping in to the edge, has any has this problem or know a way to fix this if there is any?
k40 laser with gerbil and lightburn 6.09
When i home the device the laser tries to run off bed and keeps bumping in to the edge, has any has this problem or know a way to fix this if there is any?
k40 laser with gerbil and lightburn 6.09
Quote from Paul on April 23, 2018, 1:12 amDid you check whether the end stops works via the command “?” You can use any gocde sender to send to commands to gerbil. If the an axis homes in the wrong direction you can fix that by changing “$3=“ to an appropriate value (x=1, y=2, both = 3”).
if the end stops work in the opposite way (NO instead of NC/normally closed) you can change the limit pins setting. Via $5 (invert limits).
Did you check whether the end stops works via the command “?” You can use any gocde sender to send to commands to gerbil. If the an axis homes in the wrong direction you can fix that by changing “$3=“ to an appropriate value (x=1, y=2, both = 3”).
if the end stops work in the opposite way (NO instead of NC/normally closed) you can change the limit pins setting. Via $5 (invert limits).