Laser dont shut off
Just hooked up my rotary using lightburn and setting it up drew a 10x10mm sq its cutting from the center of the work. i have $32=1 so what else can i check.
Uploaded files:
Hi Riley,
Did the controller work ok in normal XY mode (not rotary?). If so, the most likely thing is you accidentally bumped and disconnected your PWM wire (inidividual wire from Mini Gerbil to IN on your power supply). Or perhaps your LO wire at the Power Supply end.
The next thing to check is your $ settings, type $$ in the console and press enter. The settings are listed in numerical order and should include:
$30=1000
$31=1
$32=1
If you have different values, that's likely a problem. To change them back to the above, just type it in the console, such as $31=1
Regards,
Dan
Yeah the PMW wire looked like it was seated but it wasnt seems to be working now