Forum Navigation
Having trouble
#1 · March 16, 2019, 10:26 am
Just installed the Mini Gerbil, went to the section on using it with Inkscape, followed the "make a circle" instructions, but when I hit "apply," I received the following error message:
Traceback (most recent call last):
File "laser.py", line 48, in <module>
from svgpathtools import *
ImportError: No module named svgpathtools
Dead in the water. Ideas?
Thank you!
Doug
Brian_EBA has reacted to this post.
Brian_EBA
#2 · March 17, 2019, 6:13 am
Just a follow up. I uninstalled and reinstalled Inkscape, got the same error message. I was able to get the machine to home using a G code sender.
#3 · March 17, 2019, 7:55 pm
drdgscott - Please see the post just below this one from paradug about the svgpathtools - he came up with a solution and it is listed in that topic.
Brian_EBA has reacted to this post.
Brian_EBA
#4 · March 18, 2019, 4:06 am
Thank you!