Gerbil & LightBurn setup
Quote from Phindar on April 1, 2018, 10:55 pmHi Paul ,
I have installed light burn laser as it looks to be very good and also has your gerbil in the device listing :).
My issue is when the laser is homing and stops about 50mm from home position i get MSG:Check Limits message.
The gerbil profile is auto set at 300mm x 220mm with rear left as home point .
Have you by chance tried your k40 with lightburn if so is there any other settings for the gerbil to be able to use lightburn.
Hi Paul ,
I have installed light burn laser as it looks to be very good and also has your gerbil in the device listing :).
My issue is when the laser is homing and stops about 50mm from home position i get MSG:Check Limits message.
The gerbil profile is auto set at 300mm x 220mm with rear left as home point .
Have you by chance tried your k40 with lightburn if so is there any other settings for the gerbil to be able to use lightburn.
Quote from Phindar on April 2, 2018, 8:19 amupdate : I have got light burn to communicate with gerbil and now I have a problem with it stopping mid way through a engraving any thoughts .
Kind regards
nathan
update : I have got light burn to communicate with gerbil and now I have a problem with it stopping mid way through a engraving any thoughts .
Kind regards
nathan