Forum Navigation
Error messages
#1 · September 4, 2020, 12:53 am
Hello, recently my mini gerbil on my laser cutter has been having some issues and I don't know why. I get door 0 and door 2 alarms a lot and then the engraving stops.
I don't have a door switch thing installed so I don't know why I'm getting those codes, is there a way to fix this? It was working fine for almost a month but now this has recently started happening. Im using lightburn.
Thanks,
Casey
#2 · September 4, 2020, 2:00 am
I also sometimes get a restoring spindle command and frequently get the check door message, sometimes an error 1 or 2 when trying to engrave also along with the door alarms.
#3 · September 5, 2020, 12:20 am
Been messaging dan and he's gonna send a replacement out. Hope that solves all my problems.
Paul has reacted to this post.
Paul