Forum Navigation
Error in lighburn when starting work or going to origin
#1 · July 9, 2019, 10:03 pm
I have a problem when using Lighburn, when I move manually I have no problem, even the home does it well but when I start a job, the pointer goes to the middle of the board and starts from there or if I give it to go to home (not home) It also goes to the middle of the board as if it recognized the beginning in the middle of the board and makes a lot of noise.
I leave video to illustrate, any idea?
#2 · July 11, 2019, 10:32 pm
I've solved it, it was the cable ...
But I have another error, when starting work, it stays like 10-20 seconds at a slow pace and then starts at speed.