Forum breadcrumbs - You are here:ForumK40 Gerbil Controller installation: Help with installing the Gerbil controllerCould not Set :max Power
Could not Set :max Power
Lettoz@lettoz
2 Posts
#1 · August 27, 2019, 2:42 am
Quote from Lettoz on August 27, 2019, 2:42 amHello,
i installed the Mini Gerbil into my K40 with digital Panel.
I disconnected the PWM wire from the Digipanel an connect the PWM port from the Minigerbil to the PSU.
When i use Lightburn it makes noch difference which value i set at $30.
whether i set it to 1000 or to 100. I did this in the Software too but it will always be the same output power to the laser ( 26ma).when i change the Power from 100 to 60% in the programm it works.Is there a way to tell lightburn an the Mini Gerbil that 100% in Lightburn is ~16ma on the laser?I hope i could explain it right.greetings Harry
Hello,
i installed the Mini Gerbil into my K40 with digital Panel.
I disconnected the PWM wire from the Digipanel an connect the PWM port from the Minigerbil to the PSU.
When i use Lightburn it makes noch difference which value i set at $30.
whether i set it to 1000 or to 100. I did this in the Software too but it will always be the same output power to the laser ( 26ma).
when i change the Power from 100 to 60% in the programm it works.
Is there a way to tell lightburn an the Mini Gerbil that 100% in Lightburn is ~16ma on the laser?
I hope i could explain it right.
greetings Harry
Click for thumbs down.0Click for thumbs up.0
#2 · August 27, 2019, 5:51 am
Quote from Lettoz on August 27, 2019, 5:51 amfound it for my own.
I set §30=1000 an in Lightburn i set S-value max to 550
So 100% ist now 16ma
found it for my own.
I set §30=1000 an in Lightburn i set S-value max to 550
So 100% ist now 16ma
Click for thumbs down.0Click for thumbs up.1
Paul has reacted to this post.
Paul