Forum Navigation
X/Y limits
#1 · May 23, 2018, 4:16 pm
I have an inkscape page which is 200x150 and drew the circle as per the illustrations and sent it to the laser. The laser homed, then homed maybe 3 more times (I assume it's verifying calibration) then proceeded to go to the far side of the page to draw the circle, running past the location it should have been and then ground away at the end of the X-Axis for a while before completeing the circle.
I checked that there was no scaling going on but it all seems to be ok. Is there something I'm missing?
#2 · July 13, 2018, 8:57 pm
Check whether the settings in Inkscape are Inches. They must be mm. If not then check the controller settings by sending a $$ command via a gcode sender and read out the results. Maybe a setting related to the x and or y axis is off.
Cheers,
Paul
awesome.tech