Forum Navigation
Control Panel Board
#1 · April 28, 2018, 3:23 am
Hi,
Is there the possibility to install this card that is originally planned for the motherboard of the machine?
CO2 Laser Rubber Stamp Engraving Machine K40 LIHUIYU M Mother Control Panel Board Co2 Laser Engraver Cutter DIY 3020 3040
Uploaded files:
#2 · April 30, 2018, 6:01 am
This card is a separate sytem which makes it hard to incorporate it. It should be possible to include a pwm switch between gerbil and this manual dig control board. I’m thinking of an application where you are cutting so you can adjust the cutting via the dig control board instead of the Inkscape cutting plugin.
Cheers,
Paul
awesome.tech