Steppers Stalling
Quote from Sevrance on July 21, 2018, 6:57 amInstalled the new board, everything runs.. but whenever I go over 35 mm/s my steppers stall about 50% of the time (only on the start of the run).
I have checked and tightened the belts.. there was no issue with stall on the old board.
I am using Lightburn. I am sure its a GRBL setting, I just dont know which one, any help would be appreciated.
Installed the new board, everything runs.. but whenever I go over 35 mm/s my steppers stall about 50% of the time (only on the start of the run).
I have checked and tightened the belts.. there was no issue with stall on the old board.
I am using Lightburn. I am sure its a GRBL setting, I just dont know which one, any help would be appreciated.
Quote from Sevrance on July 21, 2018, 7:10 amdisregard, Im a noob.
For future reference of other noobs,
$120=50.000 (x accel, mm/sec^2)
$121=50.000 (y accel, mm/sec^2)My stepper acceleration was set at 3000, dropping it to 2000 fixed the issue. I will play with it and see how close to 3000 I can get before I go back to stalling.
disregard, Im a noob.
For future reference of other noobs,
$120=50.000 (x accel, mm/sec^2)
$121=50.000 (y accel, mm/sec^2)
My stepper acceleration was set at 3000, dropping it to 2000 fixed the issue. I will play with it and see how close to 3000 I can get before I go back to stalling.