EDIT YOUR PROFILE HERE

Please or Register to create posts and topics.

Problem with install

I grabbed the Gerbil a couple of months ago, just now getting around to finding the time to install it.

 

I followed the install procedure, everything seems fine.  Switching the wires was easy, everything looks exactly as it should in the pictures.

I turn it on, everything is seems fine, green light comes on on the Gerbil.

The PC seems to be connecting fine with it, though Inkscape is not working for me.

I went and did a test circle shape, used the extension, and turned off homing (I do not have limit switches) and turned on stream.  When I hit apply the laser goes three or so times and then nothing else, inkscape shows no errors or anything.

I then went and tried it with LaserWeb and LightBurn, both of which work almost.  With both, when I try to move in the X- direciton it only goes +.  Basically, x- and x+ both move the motor x+.  This is not a code error as I see the -1 command sent yet it goes +1.

 

So I guess I need help in two directions.  1) How can I get this to work with Inkscape directly?  and 2) How can I fixe my x- error?

To clarify with the X-1 bit, it is not "reversing" the X movement.  Literally every X command sends it to the right...  This did not happen with the original controller, there must be something wrong with my Gerbil setup.

Hi , I completely missed this post, my apologies. I am pretty sure your k40 shield has a bad connection or solder joint. PM me and we swap it out.

Cheers, Paul awesome.tech

Forum Registration

EDIT YOUR PROFILE HERE