K40 Stock PSU
Quote from Phindar on April 15, 2018, 10:40 pmHey guys ,
i have been experiencing problems with my gerbil what its doing is the laser Halting (Stopping) mid way through cut or engrave ,now i have read that the K40 PSu unit is pretty crap, has any one else had the same issue with there Gerbil k40 stopping during job or problems with the stock psu heating up and failing.
so please any suggestions i would appreciate greatly.
Kind regards
Hey guys ,
i have been experiencing problems with my gerbil what its doing is the laser Halting (Stopping) mid way through cut or engrave ,now i have read that the K40 PSu unit is pretty crap, has any one else had the same issue with there Gerbil k40 stopping during job or problems with the stock psu heating up and failing.
so please any suggestions i would appreciate greatly.
Kind regards
Quote from Phindar on April 17, 2018, 4:52 amHi Guys,
"UPDATE" I have finally sorted my gerbil issue ,as suspected the power supply unit was the cause of my gerbil stalling mid cut.
I installed a 24 volt power supply that i had from a CNC project i was working on directly to the Gerbil shield since then 25/25 test cuts successful ,Where before i was basically making more failed cuts than good ones .
i just wanted to share in case someone else has issues like i did ( drove me bloody insane trying to fix it ).
Hi Guys,
"UPDATE" I have finally sorted my gerbil issue ,as suspected the power supply unit was the cause of my gerbil stalling mid cut.
I installed a 24 volt power supply that i had from a CNC project i was working on directly to the Gerbil shield since then 25/25 test cuts successful ,Where before i was basically making more failed cuts than good ones .
i just wanted to share in case someone else has issues like i did ( drove me bloody insane trying to fix it ).