EDIT YOUR PROFILE HERE

Please or Register to create posts and topics.

CNCJs jogging problem

Before I give up and take up cricket as a stress release mechanism, I thought I'd throw this out to the forum.

Using the Gerbil board I'm getting weird gantry movements - note it worked fine with the original N2 Board

Using CNCJs I can home to the top left IF I place the head within 2 to 3 inches of home position.  Other than that - the Y axis grinds

After Homing, I can jog the x axis just fine in both directions

Y axis wants to move up out of range with either Y+ or Y-

Inkscape with the plug ins doesn't work at all it just sits there with an open dialogue box till I unplug the USB cable - then I get a connection error

Not sure what to do next except replenish my supply of Gummy Bears and dust off the crickety bat thingy.

Forum Registration

EDIT YOUR PROFILE HERE